SawStop CNS175-AU - Manual (Page 12)

10 SawStop 10” Contractor Saw
Warning Labels
Warning labels are mounted on the left side of the saw, on the table insert, on the switch box, on the belt
guard, and on the blade guard. Some of the warnings on those labels may be additional to the warnings listed
above. Be sure to read the warning labels before using the saw. Copies of the English text of the warning labels are
reproduced below:
! WARNING
For your own safety, read the instruction
manual before operating this saw.
1. Wear eye protection.
2. Use the blade guard and spreader for
every operation for which it can be used,
including all through sawing.
3. Keep hands out of the line of the saw
blade.
4. Use a push-stick when required.
5. Know how to reduce the risk of kickback.
6. Do not perform any operation freehand.
7. Never reach around or over the saw blade.
8. Never try to test fire the brake system.
9. Never adjust the position of the brake
cartridge while the blade is spinning.
10. Do not try to disable the brake system.
11. Unplug the saw before changing the blade,
changing the brake cartridge or servicing.
12. Do not connect the motor directly to a
power supply.
13. Use the bypass switch only when
necessary.
14. Do not expose to rain or use in damp
locations.
15. Do not put your hands inside or
underneath the cabinet while the blade is
spinning.
16. Do not unplug or disconnect the saw from
electrical power before the blade has
stopped spinning.
Thank you for
purchasing this
SawStop ® table saw.
This saw is equipped with the
SawStop ® safety system, designed to
reduce the potential for a serious injury
in the event of accidental contact with the
saw blade.
This saw operates differently than
ordinary table saws. Each operator
must read and understand the
Owner’s Manual before
operating this saw.
!
WARNING
Moving belts and parts
can pinch, cut or crush.
Do not operate with
belt guard open.
To avoid loss of SawStop
protection during coast down,
do not turn off Main Power until
blade has stopped spinning.
WARNING !
!
WARNING
Do not remove the dust shroud because
the blade will be exposed. If you contact the
blade under the table, the blade may retract
toward you and cause a severe injury.