SawStop CNS175-AU - Manual (Page 18)

16 SawStop 10” Contractor Saw
3. Assemble the rear of the stand by attaching the remaining two
legs marked A to the rear panel marked C (see Fig. 3). Make sure
that the legs are in front of the rear panel. Bumps on the legs fit
into holes in the rear panel to align the legs. Attach the legs to the
rear panel using four M8 x 20 carriage bolts, four M8 washers,
four M8 lock washers, and four M8 hex nuts. Do not fully tighten
the nuts at this time.
Assembling Your Saw
The instructions to assemble your saw are on a poster included with your saw and are listed below. You can
follow either set of instructions to assemble your saw. In addition to the tools included with hardware pack #2 you will
also need the following tools to complete the assembly: an 8 mm socket, a 10 mm wrench, two 13 mm wrenches,
and a level or straight edge.
Assembling the Stand
1. Locate the stand components labeled A through F and hardware pack #1
(see Fig. 1). All of the hardware needed to assemble the stand is located in
the area with the blue background on hardware pack #1. In order to easily
identify the hardware used in each of the following steps, the different pieces
of hardware are numbered on the hardware pack and in the figures.
Note: If you purchased an optional SawStop ® Job Site Cart for your saw, you
may skip steps 1-14. Refer to the owner’s manual accompanying your job site
cart for instructions on how to assemble it and mount it to the saw.
4
3
2
1
A
B
A
2. Assemble the front of the stand by attaching two of the legs marked
A to the front panel marked B (see Fig. 2). Make sure that the legs
are in front of the front panel. Bumps on the legs fit into holes in
the front panel to align the legs. Attach the legs to the front panel
using four M8 x 20 carriage bolts, four M8 washers, four M8 lock
washers, and four M8 hex nuts. Do not fully tighten the nuts at this
time. Leaving the nuts loose will make it easier to align holes as
you assemble the rest of the stand.
Fig. 2
Fig. 3
4
3
2
1
A
C
A
Fig. 1
Mounting the Saw to the Stand
Washers, M8
(32 + 2 extra)
Lock Washers, M8
(24 + 2 extra)
Assembling the Stand
Hex Nuts, M8
(32 + 2 extra)
Leveling Feet
(4)
Hardware for Steps 10-14
Hardware for Steps 1-9
Carriage Bolts, M8 x 20
(24 + 2 extra) 1
2
4
5
3
Hex Screws,
M8 x 20 (4) 6
Lock Washers,
M8 (4) 8
Hex Nuts,
M8 (4) 9
Washers,
M8 (8) 7
Hardware Pack # 1