SawStop CNS175-AU - Manual (Page 21)

SawStop 10” Contractor Saw 19
Assembling
Your Saw
9. Attach a foot to the bottom of each leg as shown in
Fig. 9 by threading an M8 hex nut on each foot and
then placing an M8 washer over the nut. Insert a
foot into the hole at the base of each leg and then
place a second M8 washer and thread a second
M8 hex nut onto each foot. Do not fully tighten the
nuts. The stand is now fully assembled.
Note: If you purchased an optional SawStop ®
Contractor Saw Mobile Base for your saw, install
it now by following the instructions that came with
the mobile base.
Assembling Your Saw
Mounting the Saw to the Stand
10. Remove the saw from the box and
locate the mounting hardware. All of
the hardware needed to mount the
saw to the stand is located in the
area with the yellow background on
hardware pack #1 (see Fig. 10).
0 15
30
45
SawStop
10” Contractor Saw
Mounting the Saw to the Stand
Washers, M8 (32 + 2 extra)
Lock Washers, M8 (24 + 2 extra)
Assembling the Stand
Hex Nuts, M8 (32 + 2 extra)
Leveling Feet (4)
Hardware for Steps 10-14
Hardware for Steps 1-9
Carriage Bolts, M8 x 20 (24 + 2 extra) 1
2
4
5
3
Hex Screws, M8 x 20 (4) 6
Lock Washers, M8 (4) 8
Hex Nuts, M8 (4) 9
Washers, M8 (8) 7
Hardware Pack # 1
Fig. 9
4
2
2
4
5
Fig. 10