SawStop CNS175-AU - Manual (Page 41)

SawStop 10” Contractor Saw 39
Preparing
Your Saw
Preparing Your Saw for Use
Disconnect the power cord from the contactor box by using a Phillips screwdriver to loosen the two screws at
the top of the contactor and removing the ends of the black and white power cord wires from the screws and
then removing the end of the green power cord wire from the ground connection (see Fig. 42 and 43).
With the saw unplugged, use a Phillips screwdriver to remove the four screws on the cover of the contactor
box and remove the contactor box cover (see Fig. 41). Locate the contactor to which the black and white wires
from the power cord are attached and the ground connection to which the green wire from the power cord is
attached (see Fig. 42).
contactor
ground
power cord
remove
contactor box
cover
Fig. 41
Fig. 42 Fig. 43