Goulds Pumps 3610 - IOM - Manual (Page 85)

Maintenance
Assemble the radial end (sleeve/ball bearing pumps)
1. Install the inboard labyrinth seal (333A).
2. Place the oil rings (323) on the shaft.
3. Place the outboard labyrinth seal (333A) in the lower half of the bearing housing (134),
which is not yet attached.
4. Lift the lower half of the housing into place, positioning the inner oil rings (323) in the
bearing housing grooves.
5. Place the installed inboard labyrinth seal (333A) in the lower housing.
NOTICE:
Make sure that the expulsion port is at the 6 o'clock position and is properly seated.
6. Hand-tighten the lower housing to the case bearing flange with the case-to-bearing housing
studs (371T) and nuts (427J).
7. Install the sleeve bearing (117):
a) Place the lower half of the sleeve bearing (117) onto the shaft (122) and slide it around
the shaft into the lower bearing housing, moving the oil rings accordingly. Position the
inboard oil rings (323) in the grooves on the sleeve bearings.
Installation, Operation, and Maintenance Manual 83