Goulds Pumps 3610 - IOM - Manual (Page 39)

Commissioning, Startup, Operation, and Shutdown
7. Place the end plate over the driver shaft and locate the end plate in the annular groove at
the rear of the coupling guard half.
1. Annular groove
2. End plate
8. Repeat steps 3 through 5 for the rear end of the coupling guard half, except that you hand
tighten the bolt.
9. Slide the rear coupling guard half towards the motor so that it completely covers the shafts
and coupling.
1. Driver
2. Slide to fit
10. Install clip-on nut on the center slot of the flat tabs on the bottom part of the coupling
guard. Keep the nut on the outside
11. Insert a a plain washer and a push nut between the other flat tab and the clip-on nut. Be
certain that the push nut is nearest the clip-on nut.
Installation, Operation, and Maintenance Manual 37