Goulds Pumps 3610 - IOM - Manual (Page 38)

Commissioning, Startup, Operation, and Shutdown
3. Install clip-on nut to on one of the flat tabs on the bottom part of the coupling guard. Make
sure to align the nut with the round hole at the front end of the guard half with nut on the
outside.
4. Insert a push nut between the other flat tab and the clip-on nut.
5. Place one washer over the bolt and insert the bolt through the round hole where the push
nut and clip-on nut are located. Be sure to tighten the bolt firmly.
6. Slightly spread the opening of the remaining coupling guard half and place it over the
installed coupling guard half so that the annular groove in the remaining coupling guard half
faces the driver.
1. Annular groove
2. Coupling guard half
3. Driver
36 Installation, Operation, and Maintenance Manual