Pitco Frialator I12+ Cooking Computer for ROV Fryers - Manual (Page 5)

Solstice I12+ Cooking Computer for ROV Fryers
Pitco P/N 60149517 & 60149518
Page 5 of 32 L20-414 Rev 2
+
1.3 To start a cook:
When the display is showing the appliance has reached set
temperature and is ready to cook. Press the desired product key, and place
product into the vat. The indicator above the product key will flash to indicate the
cook timer is running. In the example above, product 4 is cooking with 2 minutes
and 28 seconds remaining. The right side display of the dual vat control shown
above, has no running cook timers, and shows .
Multiple cooks may run together. While cooks are running, the displays will always
show the cook with the least time remaining. Longer running cooks will flash their
indicators at a slower rate. Cook time remaining on these keys may be checked by
pressing the key then pressing a product key.
1.4 To cancel a cook:
Press and hold the product key to cancel a running cook. If no other cooks are pending, controller
displays will return to .
1.5 To check Actual and Set temperatures:
To view the actual vat temperature, press the key. The display will show
or , where “F” is Fahrenheit, and “C” is Celsius. After a few moments, the display
will return to , , or if no cooks are running. [Cn
mm:ss] will display for any cooks still running.
To view the set temperature, press the key twice. The display will show or
, where “F” is Fahrenheit, and “C” is Celsius. After a few moments, the display will
return to , , or , or, [Cn mm:ss] for any cook still
running.
1.6 To View Current Settings for Cook, Shake, Hold, and Hold Pre-Alarm:
To view the current settings for any product key, press the key, followed by the desired
product key. The display will show [Cn mm:ss], followed by [Sn mm:ss], then [Hn mm:ss], ending
with [Pn
mm:ss]. Where “n” is the key number, and “mm:ss” is the time setting.
After a few moments, the display will return to , , or
, or, [Cn mm:ss] for any cook still running.
Typical displays using key 4 as an example:
Key 4 Cook Time [C4] is set for 2 minutes and 28 seconds.
Key 4 Shake Time [S4] is set for 2 minutes and :00 seconds before the end
of the Cook. Default value is 00:00, or inactive.
Key 4 Hold Time [H4] is set for 15:00 minutes. This is the amount of
time cooked product may sit in holding bins before a new batch is
started. Default value is 00:00, or inactive.
Key 4 Hold Pre-Alarm [P4] is set for 00:00 and is inactive (default
setting). When activated his alarm warns the operators that the Hold
Time is about to run out.
In a few moments, the display will return to .


