Pitco Frialator Digital Thermostat - Manual

RETHERMALIZER
DIGITAL THERMOSTAT
PROGRAMMABLE FUNCTIONS
Differential temperature - Sets the temperature range above and below the
set temperature that the heating system cycles on and off
Maximum controller temperature - Sets the maximum temperature that can
be programmed into the controller
Minimum controller temperature - Sets the minimum temperature that can be
programmed into the controller
Calibration range - Enables calibration corrections to be made between
actual temperature and sensed temperature at the probe
Set temperature mode - Set temperature is programmed in this mode
Press , Display will show “SP1”
(Set temperature mode - Set temperature is programmed in this mode)
Press , Display will show “XXX” (XXX = current set temperature)
Press to change temperature setting (NOTE: If set temperature will
not adjust to desired setting, check HI and LO temperature settings)
A JUMPER WIRE MUST BE INSTALLED BETWEEN TERMINALS +5 AND -3 ON THE
BACK OF THE CONTROLLER. CONTROLLER IS NON-PROGRAMMABLE WITHOUT
JUMPER WIRE INSTALLED
*
*
*
*
*
DF1
HI
LO
CAL
SP1
ENTERING PROGRAMMING MODE
PROGRAMMING SET TEMPERATURE
*
*
*
SET
SET
* Press SET to save new temperature setting
180
ADJUST
F
SET
SET MODE
HIDDEN
PROGRAM
L20-283 rev 0