beautypg.com

Pitco Frialator I12+ Cooking Computer for ROV Fryers User Manual

Page 14

background image

Solstice I12+ Cooking Computer for ROV Fryers

Pitco P/N 60149517 & 60149518

L20-414 Rev 2

Page 14 of 32

4

Fresh Oil Supply Monitoring

This computer monitors the Jug-in-Box (JIB) fresh oil supply for oil remaining estimation and oil
supply problems. The computer will monitor utilization of the JIB from on-demand, manual top-offs,
automatic top-offs, and top-off events from other fryers in the battery.

4.1

JIB Oil Remaining:

Low JIB message

will show and toggle with the current fryer state when the

available fresh oil has dropped below the Low JIB configuration value (section 8.11.3).

Replace JIB message

will show and toggle with the current fryer state when

the available fresh oil has depleted. The operator at this time should replace the JIB with a
new, full supply.

It is not recommended to replace JIB with a less-than-full supply.

To reset the JIB Oil Remaining monitor once the supply has been replaced:

Push-and-hold

until

is displayed.

Press product key [6] (YES) to reset the fresh oil supply to the Max JIB configuration value
(section 8.11.2).

Note: Only one cooking computer in a fryer battery needs to have the oil remaining monitor enabled
(section 8.11.1).

4.2

JIB Check/Error:

For fryer configurations with the auto top-off option, the JIB error monitor displays the error
message

when an auto top-off event has occurred three

times within 15 minutes for a single frypot. This message indicates to the operator that a JIB or
its hose has been installed improperly, the JIB has been emptied and not replaced, or there is
some other fault condition.

Check the JIB and resolve any fault conditions. Press any cook key to clear the Check JIB
message.

When the Check JIB message is displayed, auto top-off for that frypot is temporarily
disabled until the message is cleared and acknowledged.