Karcher ICC 1 D Adv - Manual (Page 34)

34 English
Î Raise the suction opening by adjusting
the rollers.
Î Remove the fastening screws (1) of the
sealing strip.
Î Remove the stabilising plate.
Î Insert the new sealing strip and fasten it
with screws along with the stabilising
plate.
Note
The sealing strip must be at the top
throughout the length of the intake.
Î Adjust suction opening.
– At the rear of the suction opening, the
sealing strip must have a ground clear-
ance of 18 mm.
Adjusting the sealing strip:
Î
Drain off the suction opening.
Î Loosen the fastening screws (1) of the
sealing strip.
Î Adjust the sealing strip in such a way
that it touches the floor when the bulk
waste flap is closed.
Î Fasten the sealing strip.
Replacing the sealing strip:
Î Remove the fastening screws (1) of the
sealing strip.
Î Remove the stabilising plate (2).
Î Insert the new sealing strip and fasten it
with screws along with the stabilising
plate.
Î Adjust the sealing strip.
Î Raise waste container.
Î Remove the fastening screws (1) - (6)
of the holder plate.
Î Remove holder plate and washer.
Î Clean the sealing area.
Î Fasten the new washer using the holder
plate.
Î Unscrew the head lamps.
Î Take out the head lamps and pull out
the plug.
Note
Note the positions of the plugs.
Î Dismantle the head lamps.
Î Dismantle the head lamp casing and
hold it horizontally because the lamp
unit is not fastened.
Î Unlock the bracked and take out the
bulb.
Î Insert new bulb.
Î Reinstall in reverse sequence.
Fuses/ relays at the rear of the vehicle
1 Electrical ventilator relay
2 Pre-heating relay (only diesel applianc-
es)
3 Fuse for electrical ventilator
4 Fuse for ignition coil and preliminary
heating (only diesel appliances)
Fuse box below the steering wheel in the
fixtures panel
Î
Replace defective fuses.
Note
Only use fuses with identical safety ratings.
Adjust / replace sealing strip of bulk
waste flap
Changing the washer of the waste con-
tainer
Changing the headlight bulb
Replacing fuses