Karcher ICC 1 D Adv - Manual (Page 31)

English 31
Î Remove the oil filter from the oil filter
housing.
Î Replace oil filter if required.
Î Refill hydraulic oil.
Oil grade: see Technical Data
Î Check all hydraulic hoses and connec-
tions and ensure that they are leak-
proof.
Only Kärcher Customer Service is author-
ised to carry out maintenance tasks on the
hydraulic unit.
ƽ
Danger
Danger of scalding by boiling water! Let the
cooler cool down for at least 20 minutes.
Î
Raise waste container.
Î Pull out the securing splint on the waste
container.
Î Release the left and right safety sup-
ports and secure with splint.
Î Fill in cold water in the cooling water
compensation tank.
– If the motor is cold: Cooling water status
above the lower marking.
– If the motor is warm: Cooling water sta-
tus below the upper marking.
– The percentage of anti-frost agent in the
cooling water should not be more than
50%.
ƽ
Danger
Risk of explosion!
– Do not carry out maintenance tasks in
closed rooms.
– Smoking and naked flames are strictly
prohibited.
Î Switch off engine.
Î Raise waste container.
Î Pull out the securing splint on the waste
container.
Î Release the left and right safety sup-
ports and secure with splint.
Î Unscrew the motor cover.
„ Only diesel appliance
Î Close the fuel supply.
Î Unscrew the fuel filter.
Î Loosen covering nut and remove fuel fil-
ter along with the contents.
Î Clean or replace fuel filter.
Î Replace washer.
Î Clean fuel filter casing.
Î Replace washer.
Î Tighten covering nut firmly.
Î Fit the fuel filter again.
„ Only petrol device
Î Close the fuel supply.
Î Loosen the hose clips at the connection
nozzle of the fuel filter.
Î Remove the fuel filter.
Î Install a new fuel filter (check direction
of flow).
Î Insert the new fuel filter in the connec-
tion hoses and fasten the hose clips.
General testing:
Î
Check fuel tubes and clamps for dam-
ages and make sure they are leak-
proof.
Î Open the fuel supply.
Î Deaerate the fuel system (only diesel
appliance):
Î Raise waste container.
Î Pull out the securing splint on the waste
container.
Î Release the left and right safety sup-
ports and secure with splint.
Î Unscrew the motor cover.
Î Loosen the deaeration screws 1 and 2
by approx. 2 rotations.
Î Keep a suitable catch bin ready.
Check hydraulic unit
Check water cooler and maintain it.
Clean and replace fuel filter
Deaerate the fuel system (only diesel ap-
pliance)