Karcher ICC 1 D Adv - Manual (Page 25)

English 25
Note
The appliance is fitting with a foot brake that
can also function as a parking brake.
Î Switch to operating mode "Parking
brake" (P).
Î Press the brake pedal.
Î Press brake pedal and keep it de-
pressed.
Î Switch to operating mode "Foot brake".
Note
The appliance is fitted with tension belts,
ropes or chains for safe transport.
To unload the machine, proceed as follows:
Î
Lock parking brake.
Î Remove the tension belts, ropes or
chains from the transport eyelets.
The machine can be moved in 2 ways:
(1) By pushing it (see Moving sweeper with-
out engaging self-propulsion).
(2) By driving it (see Moving sweeper by en-
gaging self-propulsion).
Î Unscrew rear cover.
Î Shift freewheel lever (pushing opera-
tion).
Note
Do not move the machine for long distances
without engaging self-propulsion, a speed
of 10 km/h should not be exceeded.
Î Shift freewheel lever (driving operation).
Î Park the sweeper on an even surface.
Î Remove ignition key.
Î Lock parking brake.
ƽ
Danger
Risk of explosion!
– Only use the fuels specified in the Oper-
ations Manual.
– Do not refuel the machine in enclosed
spaces.
– Smoking and naked flames are strictly
prohibited.
– Ensure that no fuel reaches the hot
open surfaces.
Î Switch off engine.
Î Open fuel filler cap.
Î Only diesel appliances: Fill in diesel.
Î Only petrol device: Use regular unlead-
ed petrol.
Î Fill in the tank up to a level 1 cm below
the lower edge of the filling nozzle be-
cause the fuel expands on heating.
Î Wipe off any spilt fuel and close fuel fill-
er cap.
– Estimate the fuel requirement in order to
avoid overflows.
– Insert the fuelling gun as deep as possi-
ble into the fuel nozzle. Do not add any
more fuel once the fuelling gun stops
according to the settings.
Î Check engine oil level.
Î Check the hydraulic oil level.
Î Check water cooler and maintain it.
Î Check tyre pressure.
Î Adjust driver's seat.
Î Check suction blower channel.
Î Check setting of suction opening.
Î Check lights and ensure that they are
functioning properly.
Î Check signaling and warning systems
for proper functioning.
Î Fill the water reservoir.
Note
For description, see section on Care and
maintenance.
ṇ
Warning
Rectify any defect you may find immediate-
ly or bring the vehicle to a halt.
Î Pull seat adjustment lever outwards.
Î Slide seat, release lever and lock in
place.
Î Check that the seat is properly locked in
position by attempting to move it back-
wards and forwards.
Set the inclination of the back-rest..
Î
Release back-rest.
Î Pull upward the unlocking lever of the
back-rest.
Î Change the inclination of the back-rest
via the position of the upper body.
Î Release unlocking mechanism.
Î Press button.
– Drawn out: max. speed
– Pushed in: min. speed
Î Turn the button.
– In clock-wise direction: min. speed
– Anti-clockwise direction: max. speed
Î Sit on the driver's seat.
Î Do not press the accelerator pedal.
Î Lock parking brake.
Î Engine speed adjustment - pull out 1/3
Î Turn the ignition key to position "I".
Pre-heat lamp glows.
Î When the pre-heating lamp goes off,
turn the ignition key to position "II".
Î If the machine starts, release the igni-
tion key.
Before Commissioning
Parking brake/ foot brake
Unloading
Moving sweeper without engaging
self-propulsion
Moving sweeper by engaging self-
propulsion
Start up
General notes
Refuelling
Fuelling using a can
Fuelling using the fuelling gun
Inspection and maintenance work
Operation
Adjusting driver's seat
Adjust engine speed
Rough tuning
Fine tuning
Starting the machine
Pre-heating (only diesel appliances)
Start motor (only diesel appliances)