Karcher ICC 1 D Adv - Manual (Page 32)

32 English
Î Start engine until fuel free of air bubbles
is released.
Î Tighten the deaeration screws.
Î The air filter is to be cleaned or replaced
when the red air filter indicator glow.
Î Raise waste container.
Î Pull out the securing splint on the waste
container.
Î Release the left and right safety sup-
ports and secure with splint.
Î Loosen the clamps of the closing lid.
Î Remove covering lid.
Î Remove and clean the filter cartridge.
Î Insert new filter cartridge, if required.
Î Clean the screw cap.
Î Replace the screw cap and clamp it.
Î Grease the lubricating nipple in the cen-
tre of the front axle.
Î Grease the right lubrication nipples of
the front axle.
Î Grease the left lubrication nipples of the
front axle.
Î Grease both the lubrication nipples on
the top and at the bottom of the mecha-
nism to raise the side-brushes.
Î Raise waste container.
Î Pull out the securing splint on the waste
container.
Î Release the left and right safety sup-
ports and secure with splint.
Î Unscrew the motor cover.
Î Check the V-Belt of the bloweer system
for damage and wear and tear.
Î Check the V-Belt drive of the hydraulic
pump and the light machine for damage
and wear and tear.
Note
The V-Belt is tightened with the help of a
spring.
Î Park the sweeper on an even surface.
Î Connect air pressure testing device to
tyre valve.
Î Check air pressure and adjust if re-
quired.
ƽ
Danger
When carrying out repairs on public high-
ways, wear warning clothing when working
close to passing traffic.
ƽ Danger
Risk of injury!
Î
Park the sweeper on an even surface.
Î Remove ignition key.
Î Check stability of ground. Also secure
the machine with wheel chock(s) to pre-
vent it rolling away.
Î Lock parking brake.
Check tyres
Î
Check tyre contact face for foreign ob-
jects.
Î Remove objects found.
Î Use suitable, commercially available
materials to carry out tyre repairs.
Note
Observe the manufacturer's recommenda-
tions. The journey may be resumed provid-
ing that the directions supplied by the
product manufacturer have been observed.
The tyre/wheel change should nonetheless
be carried out as soon as possible.
Intake point for the jack (front wheels)
Intake point for the jack (rear wheels)
Î
Insert the steel rod with 20 mm diameter
in the prescribed hole.
Î Position vehicle jack at the appropriate
mounting point for the front or rear
wheel.
Î Loosen wheel nuts.
Î Raise machine using vehicle jack.
Î Remove wheel nuts.
Î Remove wheel.
Î Mount spare wheel.
Î Fix the wheel nuts.
Î Lower machine using vehicle jack.
Î Tighten wheel nuts.
Note
Follow the symbol sticker (jack) at the re-
spective wheel changing point.
Note
Use a suitable commercially available vehi-
cle jack.
Î Check tyre pressure.
Î The side-brushes lift up.
Cleaning and replacing the fuel filter
Lubricating the front axle
Lubricte the raising mechanism of the
side-brushes
Checking the V-Belt
Check the tyre pressure
Air pressure, front 2.9 bar
Air pressure, rear 2.9 bar
Replacing wheel
Check and adjust sweeping track of the
side-brush