Swiftech H20 X20 EDGE SERIES User Manual
Page 11
Copyright Swiftech 2010
– All rights reserved – Last revision date: 8-17-10 - Information subject to change without notice – URL
Rouchon Industries, Inc., dba Swiftech
– 151 West Victoria Street, Long Beach, CA 90805 – Tel. 310-763-0336 – Fax 310-763-7095 - E Mail: [email protected]
11 of 16
Default: using the provided long Philips screws (M3,5 X 30mm or 6-
32 x 1 1/4”), thru the computer panel, the fan and to the radiator
(with or without fan guard at your choice), as shown below. Note that your radiator is shipped with the long Philips screws already pre-
installed. 3D illustrations are provided in the installation CD.
Using the provided short 6-
32 x 3/8” Philips screws (or M3,5x10mm), to fasten the fans to the radiator first thru the lower lip of the fan,
and then using the provided snap-rivets to fasten the radiator assembly to the case:
Hanging the radiator with the provided alternate corner braces.
When there are no pre-drilled holes to fasten the MCR Drive radiator to the case, corner braces can be used to hang the unit between
two panels for
example; use a #27 (.144” or 4mm) drill bit to drill the necessary holes in the panel. 3D Illustrations are provided in the
installation CD.
Short 6-
32 x 3/8” screws
Snap-rivets
Long M3,5 x 30mm or 6-
32 x 1 1/4” Philips screws