Allied Telesis AT-8350GB - Manual (Page 62)

Installation
62
Installing an Expansion Module
Caution
To avoid any damage to the switch or module, make sure that the
switch is powered OFF before attempting to install an expansion
module.
This section describes how to install an optional expansion module. The
AT-8350GB switch comes with one expansion slot which is located on
the back panel of the switch.
To install an expansion module, follow these steps:
1. Unpack the expansion module from its shipping container and store
the packaging material in a safe location.
Note
You must use the original shipping material if you need to return
the module to Allied Telesyn.
2. Check that the expansion module package includes all the items
listed below. If any item is missing or damaged, contact your Allied
Telesyn sales representative for assistance.
‰ One Expansion Module
‰ Installation Guide
‰ Warranty card
3. Face the back panel of the switch and locate the expansion slot (left
side of switch).
4. To remove the expansion slot faceplate, carefully loosen the
installation screws found on the left and right sides of the faceplate,
as displayed in Figure 35.
Note
If removing an expansion module, store the module in an antistatic
bag or immediately install it in another switch.