Selecting a site for the switch – Allied Telesis AT-8350GB User Manual
Page 54
Installation
54
Selecting a Site for the Switch
Observe the following requirements when choosing a site for your
switch:
If you plan to install the switch in an equipment rack, check to be
sure that the rack is safely secured and that it will not tip over.
Devices in a rack should be installed starting at the bottom, with
the heavier devices near the bottom of the rack.
If you are installing the switch on a table, be sure that the table is
level and secure.
The power outlet for the switch should be located near the unit
and should be easily accessible.
The site should allow for easy access to the ports on the front of
the switch. This will make it easy for you to connect and
disconnect cables, as well as view the switch’s LEDs.
To allow proper cooling of the switch, air flow around the unit and
through its vents on the side and rear should not be restricted.
Do not place objects on top of the switch.
Do not expose the switch to moisture or water.
Make sure that the site is a dust-free environment.
You should use dedicated power circuits or power conditioners to
supply reliable electrical power to the network devices.
When stacking switches, a common power source such as a
power strip is recommended for all of the switches in the stack.