Allied Telesis AT-8700XL Series Switch - Manual (Page 51)

Operating the switch 51
Software Release 2.6.1
C613-02030-00 REV B
Saving the Switch’s Configuration
To view the switch’s current dynamic configuration, enter the command:
SHOW CONFIGURATION DYNAMIC
To save any changes made to the dynamic configuration after the switch last
restarted (booted) across a restart or power cycle, and save the modified
configuration as a script file, enter the command:
CREATE CONFIG=filename.scp
To set the switch to execute this script file when it restarts, enter the command:
SET CONFIG=filename.scp
The configuration file created by CREATE CONFIG command records passwords in
encrypted form, not in cleartext.
You can create a script file from any of the switch software commands. These
are the same commands that are used to change the switch’s configuration
dynamically. Manually edit a configuration file using the switch’s built in
editor (see “Using the Built-in Editor” on page 60), or upload it to a PC using the
UPLOAD command (see the Operation chapter, AT-8700XL Series Software
Reference), edit it using any text editor, and download it again. Give
configuration script files an extension of
.scp or .cfg .
To display the name of the configuration file that is set to execute when the
switch restarts, enter the command:
SHOW CONFIG=filename
Storing Multiple Scripts
You can store multiple configuration scripts on the switch. This allows you to
test new configuration scripts once, before setting them as the default
configuration. For example, to test the new configuration script
test.cfg ,
enter the command:
RESTART SWITCH CONFIG=test.cfg
Storing multiple scripts also allows you to keep a backup switch with
configuration scripts stored on it for every switch in the network to speed up
network recovery time.