Allied Telesis AT-S65 - Manual (Page 94)

Chapter 7: Setting Up the MissingLink Feature
94
Enabling or Disabling MissingLink
To enable or disable the MissingLink feature on the port or line side,
perform the following procedure:
1. From the Main Menu, select Module Status and Configuration.
The Module Status and Configuration Menu is shown in Figure 24 on
page 52.
2. Select the line card whose MissingLink status you want to change and
press Enter.
The Module Status Menu for that line card is displayed. An example of
that menu is shown in Figure 31 on page 70.
3. Select Port Missing Link or Line Missing Link.
The options are:
Enabled - Enables port MissingLink or line MissingLink. This is the
default.
Disabled - Disables port MissingLink or Line MissingLink.
4. Press Enter to change the selection.
5. Return to the Main Menu.