Allied Telesis AT-S65 - Manual (Page 25)

AT-S65 Management Software User’s Guide
25
The System Configuration Menu is shown in Figure 4 on page 22.
2. From the System Configuration Menu, select IP Parameters and
press Enter.
The IP Parameters Menu is shown in Figure 5 on page 23.
3. Adjust the following parameters as necessary:
Manager Address1 through Manager Address 4
Specifies up to four IP addresses of network management stations that
will receive SNMP traps from the chassis. This is optional.
4. After you have adjusted the parameters, return to the Main Menu.
Configuring the
SNMP
Community
Strings
To configure the SNMP community strings, perform the following
procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu is shown in Figure 4 on page 22.
2. From the System Configuration Menu, select IP Parameters and
press Enter.
The IP Parameters Menu is shown in Figure 5 on page 23.
3. Adjust the following parameters as necessary:
Get Community String
The default setting for this string is “public.”
Set Community String
A default setting for this string is “private.”
Trap Community String
The default setting for this string is “public.”
4. After you have adjusted the parameters, return to the Main Menu.
Enabling or
Disabling DHCP
The Dynamic Host Control Protocol (DHCP) client software is included
with the AT-S65 management software. When you enable DHCP, the
system obtains its IP address, subnet mask, and default gateway address
from the DHCP server. In order for this feature to work, there must be a
DHCP server that resides on your network.
Note
Enabling DHCP overrides any IP configuration settings that you
manually assigned.