Allied Telesis AT-S65 - Manual (Page 44)

Chapter 2: Basic Parameters
44
Returning the AT-S65 Management Software to the Factory Default
Values
To return the AT-S65 management software to the factory default values,
perform the following procedure:
1. From the Main Menu, select Administration.
The Administration Menu is shown in Figure 13 on page 37.
2. From the Administration Menu, select Reset Database to Default and
press Enter.
The message in Figure 21 is displayed.
Figure 21. Reset Management Software Menu
3. Select Yes and press Return.
The following message is displayed:
Database has been set to default, now rebooting the
system . . .
The software is reset to the default values (see Appendix A, “AT-S65
Management Software Default Settings” on page 95), the system is
rebooted, and you must log in again.
Note
The system time and date are not reset to the default values.
Reset database to default now? (Yes or No):
Yes
> No
Return to Administration Menu ...