Displaying sfp vendor information – Allied Telesis AT-S65 User Manual
Page 73
AT-S65 Management Software User’s Guide
73
The detailed SFP transceiver information is displayed, as shown in
Figure 32. The information varies depending upon the SFP transceiver
whose information you are displaying.
Figure 32. Detailed SFP Transceiver Information Menu
4. Return to the Main Menu.
Displaying SFP
Vendor
Information
To display SFP vendor information, perform the following procedure:
1. From the Main Menu, select Module Status and Configuration.
The Module Status and Configuration Menu is shown in Figure 24 on
page 52.
2. Select the line card whose information you want to display and press
Enter.
The Module Status Menu for that line card is displayed. An example of
that menu is shown in Figure 31 on page 70.
3. Select Vendor Information and press Enter.
Module Information Menu
1: AT-LX3811
Type of Serial Transceiver:
3(Vendor Specific)
SONET Compliance Codes:
22(OC 12, single mode intermediate reach)
Gigabit Ethernet Compliance Codes:
2(1000BASE-LX)
Fiber Channel Link Length:
20(Intermediate)
Fiber Channel Transmitter Type:
1(Long wave laser)
Fiber Channel Media Type:
1(Single mode fiber)
Fiber Channel Speed:
14 (400MB/s)
Encoding:
05(8B10B)
Normal Baud Rate:
19(2.5GHz)
9micro, Distance:
2(Not supported)
50micro, Distance:
0(Not Supported)
60micro, Distance:
0(Not Supported)
CU, Distance:
0(Not Supported)
Transmit Disable:
1(Supported)
Laser Fault:
1(Supported)
Signal Detect(Logical 0):
0(Not Supported)
Signal Detect(Logical 1):
1(Supported)
Upper Baud Rate Margin:
60(96%)
Lower Baud Rate Margin:
08(8%)
Return to previous menu ...