Configuring the trap parameters – Allied Telesis AT-S65 User Manual
Page 30
Chapter 2: Basic Parameters
30
Configuring the Trap Parameters
The trap parameters specify which traps are sent to the SNMP
management stations specified in “Configuring the Manager IP
Addresses” on page 24.
To set the trap parameters, perform the following procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu is shown in Figure 4 on page 22.
2. From the System Configuration Menu, select Trap Parameters and
press Enter.
The Trap Parameters Menu is shown in Figure 8.
Figure 8. Trap Parameters Menu
The numbers following each trap relate to the list of IP addresses of
management stations as shown in Figure 6 on page 27.
The number “1” following a trap represents “Manager Address1” in the
IP Parameters Menu, number “2” represents “Manager Address2,” and
so forth. You use this numbering to control which management
stations receive which traps. For example, if you want “Manager
Address1” and “Manager Address3” to receive the RPS traps, then
Trap Parameters Menu
Chassis Over-Temperature:
0
Module Over-Temperature:
0
SFP Over-Temperature:
0
SFP Rate Change:
0
SFP Loss of Signal:
0
Module Loss of Signal:
0
Module Out of Sync:
0
SFP Insert/Removal:
0
Module Insertion/Removal:
0
RPS Failure:
0
RPS Insertion/Removal:
0
Port Active/Shutdown:
0
Fan Failure:
0
Link Test:
0
Missing Link:
0
Cold Start:
0
Authentication:
0
Return to System Configuration Menu ...