Allied Telesis AT-WA7400/EU - Manual (Page 351)

AT-WA7400 Management Software User’s Guide
351
bridge-port Bridge ports of bridge interfaces
bss Basic Service Set of radios
cluster Clustering-based configuration settings
cluster-member Member of a cluster of like-configured
accesspoints
config Configuration settings
detected-ap Detected access point
dhcp-client DHCP client settings
dot11 IEEE 802.11 (all radios)
host Internet host settings
interface Network interface
ip-route IP route entry
klog-entry Kernel log entry
log Log settings
log-entry Log entry
mac-acl MAC address access list item
ntp Network Time Protocol client
portal Guest captive portal
radio Radio
radius-user RADIUS user
ssh SSH access to the command line interface
supported-rate Supported rates of radios
system System settings
telnet Telnet access to the command line
interface
tx-queue Transmission queue parameters
wme-queue Transmission queue parameters for
stations
ˆ Example 3: Type get system v TAB. This will result in completion
with the only matching field, get system version . (Press ENTER
to get the output results of the command.)
AT-WA7400# get system v