Allied Telesis AT-WA7400/EU - Manual (Page 315)

AT-WA7400 Management Software User’s Guide
315
wpa-allowed off
wpa2-allowed off
rsn-preauthentication off
Set Security to WPA/WPA2 Personal (PSK)
1. Set the Security Mode
AT-WA7400# set interface wlan0 security wpa-personal
2. Set the WPA Versions
Select the WPA version based on what types of client stations you want to
support, as shown in Table 16.
The following example sets the access point to support Both WPA and
WPA2 client stations:
AT-WA7400# set bss wlan0bssInternal wpa-allowed on
AT-WA7400# set bss wlan0bssInternal wpa2-allowed on
3. Set the Cipher Suites
Table 16. WPA Version
Function Command
WPA: If all client stations on the network
support the original WPA but none
support the newer WPA2, then use WPA. set bss wlan0bssIngernal wpa-allowed on
set bss wlan0bssIngernal wpa2-allowed
off
WPA2: If all client stations on the network
support WPA2, use WPS2 which
provides the best security based on the
IEEE 802.11i standard. set bss wlan0bssIngernal wpa-allowed off
set bss wlan0bssIngernal wpa2-allowed on
Both: If you have a mix of clients, some
of which support WPS2 and others which
support only the original WPA, use Both.
This lets both WPA and WPA2 client
stations associate and authenticate, but
uses the more robust WPA2 for clients
that support it. This WPA configuration
allows more interoperability at the
expense of some security. set bss wlan0bssIngernal wpa-allowed on
set bss wlan0bssIngernal wpa2-allowed on