Allied Telesis AT-WA7400/EU - Manual (Page 262)

Appendix C: Troubleshooting
262
The Stop Clustering page for this access point is displayed, as shown
in Figure 37.
Figure 37. Stop Clustering Page
2. Click Stop Clustering.
Repeat this stop clustering step for every access point in the cluster.
Caution
Do not proceed to the next step of resetting any access points until
you have stopped clustering on all of them. Make sure that you first
stopping clustering on every access point on the subnet, and only
then perform the next part of the process of resetting each one to
the factory defaults.
3. Go to the web pages of the access point you want to reset by entering
its URL into the address bar of your web browser:
http:// IPAddressOfAccessPoint /
Where IPAddres0sOfAccessPoint is the IP address of the access
point you want to reset.
4. From the main menu, choose Advanced > Reset Configuration.