Allied Telesis AT-WA7400/EU - Manual (Page 284)

Appendix D: Command Line Interface (CLI) for Access Point Configuration
284
Field Value
---------------------
ip 10.10.55.216
mac 00:a0:c9:8c:c4:7e
Get Common Information on All Interfaces for an Access Point
The following example shows common information (including IP
addresses) for all interfaces:
Get the Firmware Version for the Access Point
In the following example, the access point is running Firmware Version:
1.0.0.9. Use the
get command as shown to obtain the Firmware Version.
AT-WA7400# get system version
1.0.0.9
Get the Location of the Access Point
In the following example, the location of the access point has not been set.
Use the
get command as shown to obtain the location of the access
point.
AT-WA7400# get interface
name type status mac ip mask
--------------------------------------------------------------------------------
lo up 00:00:00:00:00:00 127.0.0.1 255.0.0.0
eth0 up 00:02:B3:01:01:01
eth1 down 00:02:B3:02:02:02
br0 bridge up 00:02:B3:01:01:01 10.10.100.110 255.255.255.0
brguest bridge down 00:00:00:00:00:00
wlan0 service-set up 00:0C:41:16:DF:A6
wlan0guest service-set up
wlan0wds0 wds down
wlan0wds1 wds down
wlan0wds2 wds down
wlan0wds3 wds down
AT-WA7400#