Allied Telesis AT-WA7400/EU - Manual (Page 304)

Appendix D: Command Line Interface (CLI) for Access Point Configuration
304
AT-WA7400# get host dns-via-dhcp
up
Setting Up the
Wireless
Interface
To set up a wireless (radio) interface, configure the following on each
interface (Internal or guest) as described in other sections of this CLI
document.
ˆ Configure the Radio Mode and Radio Channel as described in
“Configuring Radio Settings” on page 147.
ˆ Configure the Network Name as described in “Configuring Internal
Wireless LAN Settings” on page 102.
Setting Up
Security
Note
Before configuring this feature, make sure you are familiar with the
names of the interfaces as described in “Understanding Interfaces
as Presented in the CLI” on page 278. The interface name you
reference in a command determines whether a setting applies to a
wired or wireless interface, the internal or guest network, or (on a
two-radio access point) to radio one or radio two.
The following sections show examples of how to use the CLI to view and
configure security settings on the access point. These settings correspond
to those available from the web UI on the Advanced > Security page. For a
detailed discussion of concepts and configuration options, see Chapter
10, “Configuring Security” on page 105.
This section focuses on configuring security on the internal network.
(Security on the guest network defaults to plain text. See “Plain Text” on
page 115.)
Table 10 shows a quick view of Security commands and links to detailed
examples.
Table 10. Security Commands
Function Command
Get the Current Security
Mode get interface wlan0 security
Get Detailed Description of
Current Security Settings get bss wlan0bssInternal detail
get interface wlan0 detail
Set the Broadcast SSID
(Allow or Prohibit) set radio wlan0 ignore-broadcast-ssid on
set radio wlan0 ignore-broadcast-ssid off