Allied Telesis AT-WA7400/EU User Manual
Page 291
AT-WA7400 Management Software User’s Guide
291
Get Common Information on the Internal Interface for the Access
Point
The following command obtains all information on the internal interface for
an access point:
AT-WA7400# get interface br0
Field Value
--------------------
type bridge
status up
hello 10
mac 00:a0:c9:8c:c4:7e
ip 192.168.1.1
mask 255.255.255.0
Get Current Settings for the Ethernet (Wired) Internal Interface
The following example shows how to use the CLI to get the Ethernet
(Wired) settings for the internal interface for an access point. You can see
by the output results of the command that the MAC address is
00:a0:c9:8c:c4:7e
, the IP address is 192.168.1.1, and the subnet
mask is 255.255.255.0.
Enable Remote Logging and
Specify the Log Relay Host for the
Kernel Log
As a prerequisite to remote logging, the Log Relay Host
must be configured first as described in “Setting Up the Log
Relay Host” on page 187.
See a complete explanation of CLI commands at “Enable
Remote Logging and Specify the Log Relay Host for the
Kernel Log” on page 295. Here are a few:
set log relay-enabled 1
enables remote logging
set log relay-enabled 1
disables remote logging
get log
set log
TAB TAB shows values you can set on the log
Get Transmit / Receive Statistics
get interface all ip mac ssid tx-packets tx-bytes tx-
errors rx-packets rx-bytes rx-errors
get association
get clustered-ap
Table 8. Status Commands (Continued)
Function
Command