Allied Telesis AT-S63 - Manual (Page 427)

AT-S63 Management Software Web Browser Interface User’s Guide
Section VII: Management Security 427
Displaying the SSL Settings
To configure the SSL settings, you must use the AT-S63 menus or
command line interface. For information, refer to the AT-S63 Management
Software Menus Interface User’s Guide and the AT-S63 Management
Software Command Line Interface User’s Guide.
To display the SSL settings, perform the following procedure:
1. From the Home page, select Monitoring.
The System page is displayed with the General tab selected by default,
as shown in Figure 6 on page 42.
2. From the Monitoring menu, select the Mgmt. Protocols option.
The Mgmt. Protocols page is displayed with the Server-based
Authentication tab selected by default, as shown in Figure 177 on page
440.
3. Select the SSL tab.
The SSL tab is shown in Figure 169.
Figure 172. SSL Tab (Monitoring)
The SSL tab provides the following information:
Maximum Number of Sessions
The maximum number of SSL sessions allowed at one time.
Session Cache Timeout
The length of time before the session cache times out, in seconds.