Allied Telesis AT-S63 - Manual (Page 158)

Chapter 11: Event Logs and Syslog Servers
158 Section II: Advanced Operations
Module Selections
Specifies the AT-S63 management software module(s) whose events
you want to send to the syslog server. To select more than one, use
+click. For a list of modules, refer to Table 1 on page 147.
5. Click Apply to apply the changes or Close to close the page without
making changes.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Deleting a Log
Output Definition
To delete a log output, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. Select the Event Log tab.
The Event log tab is shown in Figure 40 on page 143.
3. In the Configure Log Outputs section, Select the log output file that you
want to modify and click Delete.
The log output definition is deleted from the list.