Allied Telesis AT-S63 - Manual (Page 240)

Chapter 18: SNMPv3
240 Section III: SNMPv3
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure User Table
and then click Configure.
The SNMPv3 User Table tab is shown in Figure 90 on page 237.
4. Click the button next to the User Table entry that you want to delete
and then click Remove.
A warning message is displayed.
5. Click OK.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Modifying a User
Table Entry
To modify an entry SNMPv3 User Table, perform the following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure User Table
and then click Configure.
The SNMPv3 User Table tab is shown in Figure 90 on page 237.
4. Click the button next to the SNMPv3 user that you want to change and
then click Modify.