Allied Telesis AT-S63 - Manual (Page 250)

Chapter 18: SNMPv3
250 Section III: SNMPv3
Configuring the SNMPv3 Access Table
You can create, delete, and modify an SNMPv3 Access Table entry. See
the following procedures:
ˆ “Creating an Access Table” on page 250
ˆ “Deleting an Access Table Entry” on page 253
ˆ “Modifying an Access Table Entry” on page 254
For information about the SNMPv3 Access Table, see Chapter 22,
“SNMPv3” in the AT-S63 Management Software Menus Interface User’s
Guide.
Creating an
Access Table
To create an entry in the SNMPv3 Access Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure Access
Table and then click Configure at the bottom of the tab.
The SNMPv3 Access Table tab is shown in Figure 96.
Figure 96. SNMPv3 Access Table Tab (Configuration)