Allied Telesis AT-S63 User Manual
Page 153
AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations
153
4. Configure the following parameters as necessary:
Output ID
An ID number for the log output.
Output Status
Specifies whether or not the output is sent to the syslog server. The
options are:
Enabled - Enables the log output. Event messages are sent to the
defined syslog server.
Disabled - Disables the log output. Event messages are not sent to the
defined syslog server.
Message Format
Specifies the format of the messages sent to the syslog server. The
options are:
Extended - Sends the time, module, severity, description, file name,
line number, and event ID. This is the default.
Normal - Sends the time, module, severity, and description for each
event.
Severity Selections
Specifies the severity of events you want to send to the syslog server.
The possible options are:
ALL - Sends all event messages of the following types. This is the
default.
Error - Sends only error event messages. Error messages indicate that
the switch operation is severely impaired.
Warning - Sends only warning event messages. These messages
indicate that an issue may require manager attention.
Information - Sends only informational event messages. Informational
messages display useful information that you can ignore during normal
operation.
Debug - Sends debug event messages. These events provide detailed
high-volume information that is intended only for technical support
personnel.
Use
Type
The only available type is Syslog and you cannot change this.
Syslog Server IP Address
The IP address of the syslog server.