Allied Telesis AT-S81 - Manual (Page 77)

AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface 77
Working with Trap Receivers
This section contains procedures for working with SNMP trap receivers
and includes the following topics:
ˆ “Adding a Trap Receiver,” next
ˆ “Enabling or Disabling Trap Receivers” on page 77
ˆ “Modifying a Trap Receiver” on page 78
ˆ “Deleting a Trap Receiver” on page 79
Adding a Trap
Receiver
You must add a trap receiver before you can enable it.
To add a trap receiver, perform the following procedure.
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 32.
2. From the Basic Switch Configuration menu, type N to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 19 on page 75.
3. Type A to select Add SNMP Trap Receiver.
The following prompt is displayed:
Add SNMP trap receivers->Enter entry number>
4. Enter 1 through 4 for the trap receiver you want to configure.
The following prompt is displayed:
Enter IP address for trap receiver>
5. Enter the IP address of the workstation that you want to receive traps.
The following prompt is displayed:
Enter community name for trap receiver>
6. Enter a name for the workstation that you want to receive traps.
A new trap receiver is automatically enabled.
Enabling or
Disabling Trap
Receivers
You can disable a trap receiver or enable one that was previously
disabled. To enable or disable a trap receiver, perform the following
procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.