Allied Telesis AT-S81 - Manual (Page 273)

AT-S81 Management Software User’s Guide
Section II: Web Browser Interface 273
Priority
The port’s priority for receiving power from the switch. For more
information about port priority, refer to “Port Prioritization for Power
Allocation” on page 104. To set the priority, refer to “Setting the PoE
Port’s Priority” on page 273.
Power (mW)
The amount of power being delivered to the device, in Milliwatts.
Voltage (V)
The amount of voltage being delivered to the device, in Volts.
Current (mA)
The amount of current being delivered to the device, in Milliamps.
Changing the
PoE Port’s
Admin Setting
To change a port’s admin setting from up (online) to down (offline),
perform the following procedure:
1. Next to the port you whose status you want to change, select Up or
Down from the Admin list.
2. Click Apply.
Setting the PoE
Port’s Priority
The priority defines which port and its attached PoE powered device
should receive priority for the available power over other PoE devices. For
more information about port priority, refer to “Port Prioritization for Power
Allocation” on page 104.
To select the priority for each port, perform the following procedure:
1. From the Priority list, select one of the following:
Low - To change the port priority to low. This is the default.
High - To change the port priority to high.
Critical - To change the port priority to critical, so that this device
continues to receive power even if others do not.
2. Click Apply.