Allied Telesis AT-S81 - Manual (Page 127)

AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface 127
The selections in this Config VLAN Member menu are explained in
“Modifying a VLAN” on page 127.
Modifying a
VLAN
The topics in this section include:
Before performing this procedure, note the following:
ˆ You cannot change the VID of a VLAN.
ˆ You cannot add an untagged port to a VLAN with this procedure. That
function requires changing a port’s VID value, as explained in
“Configuring the Port PVID” on page 124
ˆ You cannot remove an untagged port from a VLAN with this
procedure. To remove an untagged port from a VLAN, you must
assign it as an untagged member of another VLAN by changing its
PVID, as explained in “Configuring the Port PVID” on page 124.
Changing the VLAN Name
To change the name of a VLAN, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 21 on
page 87.
2. From the Advanced Switch Configuration Menu, type V to select VLAN
Management.
The VLAN Management Menu is shown in Figure 29 on page 122.
3. Type O to select Config VLAN Member.
The following prompt is displayed:
Enter VLAN ID >
Type the number of the VLAN you want to modify and press Enter.
The Config VLAN Member menu is shown in Figure 31 on page 126.
4. Type C to select Change VLAN Name.
The following prompt is displayed:
Enter new VLAN name>
5. Type the new name for the VLAN and press Enter. A VLAN name can
be up to 32 characters and can include spaces.
Adding or Removing a Tagged Port in a VLAN