Allied Telesis AT-S81 - Manual (Page 272)

Chapter 24: Power Over Ethernet
272 Section II: Web Browser Interface
Configuring PoE
To configure the PoE settings, perform the following procedure:
1. From the Advanced Config menu, select Power Over Ethernet.
The Power Over Ethernet Configuration page opens, as shown in
Figure 81.
Figure 81. Power Over Ethernet Configuration Page
The Power Over Ethernet Configuration page displays information
about the PoE status of each port and also allows you to configure the
port’s status and priority. The table includes the following items of
information:
Admin
The status of the port, either up or down. To change the Admin
selection, refer to “Changing the PoE Port’s Admin Setting” on
page 273.
Status
Whether a PoE device is being powered or not by that port. “Powered”
means that the port is providing power to a powered device. “Not
Powered” indicates that the device is not a powered device or that no
device is connected to the port. You cannot alter this setting.
Class
The IEEE 802.3af class of the device. You cannot change this setting.
For more information, refer to “PoE Device Classes” on page 105.