Allied Telesis AT-S81 - Manual (Page 256)

Chapter 21: SNMP
256 Section II: Web Browser Interface
Working with Trap Receivers
This section contains the following procedures:
ˆ “Adding and Enabling a Trap Receiver,” next
ˆ “Disabling a Trap Receiver” on page 256
ˆ “Deleting a Trap Receiver” on page 256
Adding and
Enabling a Trap
Receiver
To add and enable a trap receiver, perform the following procedure:
1. From the Basic Config menu, select SNMP Config.
The SNMP Configuration page is shown in Figure 76 on page 255.
2. In the bottom half of the page, enter the IP address for each trap
receiver.
3. Enter the community string to associate with that trap receiver.
4. Select Enable from the list.
5. Click Apply.
Disabling a Trap
Receiver
To disable a trap receiver, perform the following procedure:
1. From the Basic Config menu, select SNMP Config.
The SNMP Configuration page is shown in Figure 76 on page 255.
2. To the right of the trap receiver you want to disable, select Disable
from the list.
3. Click Apply.
Deleting a Trap
Receiver
To delete a trap receiver, perform the following procedure:
1. From the Basic Config menu, select SNMP Config.
The SNMP Configuration page is shown in Figure 76 on page 255.
2. To the right of the trap receiver you want to disable, select Delete from
the list.
3. Click Apply.
Restoring the
Trap Receivers
To restore the trap receivers, perform the following procedure:
1. From the Basic Config menu, select SNMP Config.