Allied Telesis AT-S81 - Manual (Page 312)

Chapter 30: RADIUS Authentication Protocol
312 Section II: Web Browser Interface
Configuring the RADIUS Client
To configure the RADIUS client, perform the following procedure:
1. From the Basic Config menu, select User Interface > RADIUS
Config.
The RADIUS Configuration page opens, as shown in Figure 96.
Figure 96. RADIUS Configuration Page
2. Enter the RADIUS server’s IP address in the Server IP Address field.
3. To specify the server’s encryption key, enter the encryption key in the
Shared Secret field.
4. To change the response time setting, enter a value in the Response
Time field.
The response time is the amount of time in seconds the switch waits
for a response from the RADIUS server. The range is 1 to 120
seconds. The default is 10 seconds.
5. To change the maximum retransmissions setting, enter a new value in
the Maximum Retransmissions field.
This parameter specifies the number of times the switch should
retransmit to the RADIUS in the event the server does not respond.
The range is 1 to 254. The default is 3.
6. Click Apply to save your changes.