Allied Telesis AT-S81 - Manual (Page 101)

AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface 101
Enabling or Disabling Port Mirroring
To enable or disable port mirroring, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 21 on
page 87.
2. From the Advanced Switch Configuration Menu, type M to select Port
Mirroring Configuration.
The Port Mirroring Menu is shown in Figure 25 on page 99.
3. Type E to select Enable/Disable Port Mirroring.
The following prompt is displayed:
Enable or Disable monitoring (E/D)>
4. Type E to disable port mirroring or D to disable port mirroring. Port
mirroring is disabled by default.
When you disable port mirroring, the port that was functioning as the
mirroring port can then be used as a normal networking port.