beautypg.com

Configuration – Allied Telesis AT-GS950/8 User Manual

Page 322

background image

Chapter 25: Loopback Protection

322

Configuration

To configure the Loopback Detection feature, perform the following
procedure:

1. From the main menu on the left side of the page, select Bridge.

The Bridge folder expands.

2. From the Bridge folder, select Loopback Detection.

The AT-GS950/8 Loopback Detection Page is displayed. See
Figure 116.

Figure 116. AT-GS950/8 Loopback Detection Page

3. For the Loopback Detection State field a the top of the page, select

one of the following radio buttons:

Enabled - This selection enables the Loopback Detection feature
across the switch. This state must be enabled for the individual
port Loopback Detection State is effective.

Disabled - This selection disables the Loopback Detection feature
on the switch.