Allied Telesis AT-GS950/8 - Manual (Page 164)

Chapter 11: LACP Port Trunks
164
Port Priority Configuration
To select a priority for an LACP port, perform the following procedure:
1. Select the Bridge folder.
The Bridge folder expands.
2. From the Bridge folder, select the Trunk Config folder.
The Trunk Config folder expands.
3. From the Trunk Config folder, select Port Priority.
The AT-GS950/8 Port Priority Page is displayed. See Figure 54.
Figure 54. AT-GS950/8 Port Priority Page
The System Priority is a preassigned value that you cannot alter. This
value applies to the switch. See “System Priority” on page 157.
The System ID is a MAC address value assigned to the switch. You
cannot change this value.
4. To set the port priority, select a value from 0 to 255 in the Priority
column for the port you want to alter. For more information, see “Port
Priority Value” on page 157
5. Select Apply.
6. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.