Allied Telesis AT-GS950/8 - Manual (Page 137)

AT-GS950/8 Web Interface User Guide
137
Port Configuration
To configure the MSTP parameters for each of the ports, perform the
following procedure:
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select the Spanning Tree folder.
The Spanning Tree folder expands.
3. From the Spanning Tree folder, select the MSTP folder.
The MSTP folder expands.
4. From the MSTP folder, select MSTP Port Configuration.
The AT-GS950/8 MSTP Port Configuration Page is displayed. See
Figure 46.
Figure 46. AT-GS950/8 MSTP Port Configuration Page
You may choose a port and configure its MSTP parameters on this
page. The following information is displayed:
Port - Indicates ports 1 through 8on the AT-GS950/8 switch. Use
the All row to apply the same settings for the Point-to-Point Status,
Edge Port, MSTP Status, Protocol Migration, AutoEdge Status,
Restricted Role, Restricted TCN fields to all the ports on your
switch.
Path Cost - Specifies the cost of a port to the root.
Priority - Specifies the spanning tree port priority.
PointToPoint Status - Indicates if the port is connected to another
network device (point-to-point) in the network topology. See “Point-
to-Point and Edge Ports” on page 116 for more information.
ForcedTrue - The port is connected to a network device in the