Snmpv3 view names, Create snmpv3 view names, Figure 100. snmp group access table – Allied Telesis AT-GS950/8 User Manual
Page 280
Chapter 21: Simple Network Management Protocol SNMPv3
280
SNMPv3 View Names
The SNMPv3 View names are defined in the SNMP Group Access table
and are based on the User and Group Names. You can create and delete
View Names by following the procedures in the following sections:
“Create SNMPv3 View Names” on page 280
“Modify SNMPv3 View Names” on page 281
“Delete SNMPv3 View Names” on page 281
Create SNMPv3
View Names
This procedure explains how to create SNMPv3 View Names.
1. From the main menu on the left side of the page, select the SNMP
folder.
The SNMP folder expands.
2. From the SNMP folder, select Group Access Table.
The Group Access Table page is displayed. See Figure 100.
Figure 100. SNMP Group Access Table
3. Enter the Group Name.
Note
This entry must be pre-defined on the SNMP User/Group page. See
“Create SNMPv3 View Names” on page 280.
4. Enter the Read View Name.
This name is an optional field. It can be up to 31 characters in length.