Allied Telesis AT-TQ2450 - Manual (Page 38)

Chapter 2: Installing the Access Point
38
Figure 14. Flange on the Bottom Panel of the AT-BRKT-J26 Bracket
 You should verify that the wall or ceiling material is strong enough to
support the weight of the bracket and access point.
 If you will not be using the PoE feature, there needs to be an AC power
source near the place chosen for the access point.
 You have to provide the four screws and, if necessary, the wall
anchors, that are used to secure the bottom panel to the wall or ceiling.
 The base panel has eight screw holes. Refer to Figure 15 on page 39.
The holes are grouped in pairs. The unit should be secured to the wall
or ceiling with a minimum of four screws. You may use either screw
hole in a pair to secure the panel.
Flange