Allied Telesis AT-TQ2450 - Manual (Page 34)

Chapter 2: Installing the Access Point
34
Figure 9. Attaching the Network Cable to the LAN Port
4. Connect the other end of the network cable to a port on an Ethernet
switch.
If you are not using the PoE feature on the Ethernet port to power the
unit, continue with this procedure to attach the AC/DC power adapter.
If you are using the PoE feature on the LAN Port to power the access
point, the installation procedure is complete. Go to “Starting the Initial
Management Session on the Access Point” on page 51.
5. Connect the power cord to the AC/DC adapter. Refer to Figure 10.
Figure 10. Connecting the Power Cord to the AC/DC Adapter