Allied Telesis AT-TQ2450 - Manual (Page 27)

27
Chapter 2
Installing the Access Point
This chapter describes how to install the AT-TQ2450 Wireless Access
Point. This chapter contains the following sections:
 “Reviewing Safety Precautions” on page 28
 “Unpacking the AT-TQ2450 Access Point” on page 30
 “Installing the Access Point on a Table” on page 33
 “Installing the Access Point on a Wall of Ceiling with the AT-BRKT-J26
Bracket” on page 37
 “Installing Anti-theft Devices” on page 50
 “Starting the Initial Management Session on the Access Point” on
page 51
 “Setting the Country Setting” on page 55
Note
The non-US model of this product has a country code setting that
must be set during the initial management session of the unit. The
setting ensures that the unit operates in compliance with the laws
and regulations of your country or region.
For the US model the country code is preset and cannot be
changed. Per FCC regulations, the country code setting for all WiFi
products marketed in the US must be fixed to US operational
channels only.