Allied Telesis AT-GS950/8 - Manual (Page 287)

AT-GS950/8 Web Interface User Guide
287
See “Configuration of IPv4 Address, Subnet Mask and Gateway
Address” on page 32.
 You must specify the user name and password combinations when
configuring the RADIUS server software on the authentication server.
Note
This guide does not explain how to configure RADIUS server
software. Refer to the documentation that comes with the RADIUS
server software for instructions.
 You must activate the RADIUS client software on the switch using the
AT-S113 Management Software and configure the settings. This is
explained in “Port Access Control Configuration” on page 281 and
“RADIUS Client Configuration”.
 For more information about the RADIUS authentication protocol, refer
to the RFC 2865 standard.
RADIUS Client
Configuration
To configure the RADIUS client, perform the following procedure:
1. From the main menu on the left side of the page, select the Security
folder.
The Security folder expands.
2. From the Security folder, select RADIUS.
The RADIUS Page is displayed. See Figure 114.
Figure 114. RADIUS Page
3. Enter the RADIUS server’s IP address using one of the Server IP
Address fields:
For an IPv4 address, click IPv4, then enter the address using
xxx.xxx.xxx.xxx format.
For an IPv6 address, click IPv6, then enter the address using
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx hexadecimal format.