Allied Telesis AT-GS950/8 - Manual (Page 104)

Chapter 6: Static Port Trunking
104
A check in a box indicates the port is a member of the trunk. No check
means the port is not a member. A port trunk can contain up to 10
ports.
5. Change the trunk mode from Disable to another setting using the pull-
down menu. The choices are the following:
Active - The specific aggregator will broadcast and respond to
LACP Data Unit (LACPDU) packets. This setting enables
the LACP feature for the trunk.
Passive - The specific aggregator will not broadcast LACPDU
packets, but it will respond to them. This setting disables the LACP
feature for the trunk.
Manual - Enables static port trunking and disables the LACP
feature for the trunk.
Disable - Disables the static port trunk and disables the LACP
feature for the trunk.
6. Click Apply.
7. If you did not select the trunk mode, Disable, the trunk is now
operational on the switch.
8. From the main menu on the left side of the page, select Save Settings
to Flash to permanently save your changes.
9. Configure the port trunk on the other switch.
10. Connect the Ethernet cables between trunk ports on the AT-GS950/8
switch and the trunk ports on the other switch.